User Tools

Site Tools


demonstrations:9_equipment:av_receiver_amplifier:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
demonstrations:9_equipment:av_receiver_amplifier:start [2019/04/17 23:11]
demoroom
demonstrations:9_equipment:av_receiver_amplifier:start [2020/01/27 17:03] (current)
demoroom
Line 1: Line 1:
 ====== AV Receiver/​Amplifier ====== ====== AV Receiver/​Amplifier ======
  
-{{tag> acoustics equipment av amplifier ​unlocated}}+{{tag> acoustics equipment av amplifier ​located}}
  
-<WRAP box right>+<WRAP box right 400px>
 {{amplifier.jpg?​400|}} {{amplifier.jpg?​400|}}
  
Line 18: Line 18:
 The minimum impedances it can handle are listed on the back.  The minimum impedances it can handle are listed on the back. 
  
-<​WRAP ​center ​round important ​60%>+If you want to use a phone or other MP3 player as a source, a cable that converts RCA to 3.5mm audio jack is usually kept on the cart with the amplifier.  
 + 
 +If using the amplifier with a function generator, triple check that the function generator output is actually turned on when you're turning up the volume. Apparently, when the function generator is turned on but the output is disabled, the frequency that the generator is set to still comes through but at a much lower amplitude. This has confounded people multiple times, as it's easy to look over. 
 + 
 +<​WRAP ​left round important ​50%>
 Moderate voltages are involved with this. By estimation (60W with 8Ω speakers) it should be outputting only up to 20V... But that hasn't been tested, so take typical precautions and don't touch the leads while the volume is turned up. Moderate voltages are involved with this. By estimation (60W with 8Ω speakers) it should be outputting only up to 20V... But that hasn't been tested, so take typical precautions and don't touch the leads while the volume is turned up.
 </​WRAP>​ </​WRAP>​
Line 26: Line 30:
 </​WRAP>​ </​WRAP>​
 <WRAP tablewidth 100%> <WRAP tablewidth 100%>
-| **Location** | ---- |+| **Location** | On cart, as pictured|
 | **Maker** | Unknown | | **Maker** | Unknown |
 | **Current State** | Working | | **Current State** | Working |
demonstrations/9_equipment/av_receiver_amplifier/start.1555542681.txt.gz · Last modified: 2019/04/17 23:11 by demoroom