This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
demonstrations:8_astronomy:transit_method:start [2023/08/11 18:27] demoroom [Notes] |
demonstrations:8_astronomy:transit_method:start [2023/08/11 20:02] (current) demoroom [Setup] |
||
---|---|---|---|
Line 34: | Line 34: | ||
===== Setup ===== | ===== Setup ===== | ||
- | Suspend the diffuse light source above the rotating table. Attach a model exoplanet to the rotating table. | + | - Mount the rotating table on a sufficiently large and sturdy table. |
- | The light sensor can be placed such that when the table rotates a periodic decrease in the intensity is observed. | + | - Cover the rotating table with a black cloth. |
+ | - Suspend the diffuse light source above the rotating table. | ||
+ | - Attach a model exoplanet to the rotating table. | ||
+ | - Connect the power source (EICO 1064) to the motor in the rotating table. | ||
+ | - Start at 0V and slowly turn up the voltage until a desired rotation rate is obtained. | ||
+ | - Mount the light sensor a suitable distance away so that when the table rotates a periodic decrease in the intensity will be observed. | ||
+ | - Connect the light sensor to the Vernier LabPro interface. | ||
+ | - Connect the Vernier LabPro interface to the USB port of a computer with LoggerPro installed. | ||
+ | - Power the interface, wait for the beeps to finish and then start the LoggerPro software. | ||
+ | {{:demonstrations:8_astronomy:transit_method:transitmethodsetup.jpg?400|}} | ||
===== Notes ===== | ===== Notes ===== | ||
Line 46: | Line 55: | ||
<WRAP center round important 60%> | <WRAP center round important 60%> | ||
- | This setup involves many pieces and the setup is involved and potentially involves more than one person. | + | This setup has many pieces and the setup is involved and potentially needs more than one person. |
Please give plenty of advance notice of when the demo is needed and what room it will be needed in. | Please give plenty of advance notice of when the demo is needed and what room it will be needed in. | ||
Line 53: | Line 62: | ||
- | <WRAP group> | ||
- | <WRAP half column> | ||
- | |||
- | <WRAP box right 400px> | ||
- | {{default.jpg?400|}} | ||
- | |||
- | // Comment here // | ||
- | </WRAP> | ||
- | |||
- | </WRAP> | ||
- | <WRAP half column> | ||
- | |||
- | <WRAP box right 400px> | ||
- | {{default.jpg?400|}} | ||
- | |||
- | // Comment here // | ||
- | </WRAP> | ||
- | |||
- | </WRAP> | ||
- | </WRAP> | ||
Line 79: | Line 68: | ||
</WRAP> | </WRAP> | ||
<WRAP tablewidth 100%> | <WRAP tablewidth 100%> | ||
- | | **Location** | ---- | | + | | **Location** | Hebb 100a on a grey metal shelf on the same side as the personal desk. | |
| **Maker** | Unknown | | | **Maker** | Unknown | | ||
| **Current State** | Working | | | **Current State** | Working | |