This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
demonstrations:5_electricity_and_magnetism:5h_magnetic_fields_and_forces:electric_train:start [2020/02/04 19:59] demoroom |
demonstrations:5_electricity_and_magnetism:5h_magnetic_fields_and_forces:electric_train:start [2020/02/04 21:05] demoroom |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Electric Train ====== | ====== Electric Train ====== | ||
- | {{tag> out_of_date untagged unlocated}} | + | {{tag> electricity_and_magnetism track untagged located}} |
<WRAP box right> | <WRAP box right> | ||
Line 24: | Line 24: | ||
- | - Battery | + | - AAA Battery |
- | - 6 x 0.75" neodymium disc magnets | + | |
- | - Copper wire track (can be found wrapped around rod) | + | |
- | Procedure | + | - 6 x 0.75" neodymium disc magnets |
- | 1. Remove copper wire track from rod. | + | |
- | 2. Attach magnets to battery like so: NS Battery SN | + | - Figure 8 Copper wire track on acrylic base (featuring flag that spins as the train passes) |
- | 3. Place in track. | + | |
Line 37: | Line 34: | ||
===== Setup ===== | ===== Setup ===== | ||
+ | |||
+ | 1. Remove small detachable section of the track | ||
+ | |||
+ | 2. Attach magnets to battery like so: NS Battery SN | ||
+ | |||
+ | 3. Place train in opening of track | ||
+ | |||
+ | 4. Replace detachable section before the battery makes a full loop to make a continuous track | ||
Line 58: | Line 63: | ||
</WRAP> | </WRAP> | ||
<WRAP tablewidth 100%> | <WRAP tablewidth 100%> | ||
- | | **Location** | ---- | | + | | **Location** | Q2 | |
| **Maker** | Unknown | | | **Maker** | Unknown | | ||
| **Current State** | Working | | | **Current State** | Working | |