Table of Contents

Bernoulli's Principle

Description

A demonstration that shows the Bernoulli's principle using a scale model of an airplane wing inside a wind tunnel. Use the Fog machine to show the air flowing around the wing.

Parts needed for this demonstration : - Fog machine - Rubber ball - Wing cross-section - Shop-vc - Plastic disk and air pressure gauge apparatus Instructions: 1. Plug in the fog machine (Allow 5-10 minutes to heat up) 2. Connect the Fog machine to the wind tunnel 3. Insert one of the Wing models and screw it into place 4. Use the protractors to measure the angle at which the wing models are placed 5. Press the fog machine button to eject fog into the wind tunnel (The fog machine occasionally shoots fog on its own)

Updated: May 5th, 2015

Purpose

Apparatus

Setup

Notes

Demo room information

Location —-
Maker Unknown
Current State Working