Differences

This shows you the differences between two versions of the page.

--- demonstrations:5_electricity_and_magnetism:5a_electrostatics:electrostatic_windmill:start [2019/02/15 00:07] – demoroom
+++ demonstrations:5_electricity_and_magnetism:5a_electrostatics:electrostatic_windmill:start [2020/03/05 19:31] (current) – demoroom
@@ Line 1: / Line 1: @@
 ====== Electrostatic Windmill ======
-{{tag>van_de_graff electrostatics torque unlocated}}
+{{tag> van_de_graaff electrostatics torque located}}
 <WRAP box right>
@@ Line 11: / Line 11: @@
 ===== Description =====
-Consists of a 'wheel' or 'windmill' with radially protruding spikes ending in 90-degree turns and a stand with a needle on top that the wheel balances on.
+Consists of a conductive metal 'wheel' or 'windmill' with radially protruding spikes ending in 90-degree turns and a stand with a needle on top that the wheel balances on.
 ===== Purpose =====
@@ Line 26: / Line 26: @@
 ===== Setup =====
-Place windmill on top of the Van de Graff generator. When the generator is turned on the windmill will begin to rotate.
+Place windmill on top of the Van de Graaff generator. When the generator is turned on the windmill will begin to rotate.
 ===== Notes =====
-The Van de Graff generator vibrates significantly while running, so a piece of tape may be necessary to prevent the windmill from falling off of the generator.
+The Van de Graaff generator vibrates significantly while running, so a piece of tape may be necessary to prevent the windmill from falling off of the generator.
 The electrostatic windmill needs a high voltage to start turning, so move the grounding 'wand' far away from the head of the generator.
@@ Line 49: / Line 49: @@
 </WRAP>
 <WRAP tablewidth 100%>
-| **Location** | ---- |
+| **Location** | F1 |
 | **Maker** | Unknown |
 | **Current State** | Working |