Differences

This shows you the differences between two versions of the page.

--- demonstrations:4_thermodynamics:4e_gas_law:compression_igniter:start [2019/05/13 22:14] – demoroom
+++ demonstrations:4_thermodynamics:4e_gas_law:compression_igniter:start [2020/03/13 20:30] (current) – demoroom
@@ Line 1: / Line 1: @@
 ====== Compression Igniter ======
-{{tag> thermodynamics ideal_gas_law compression flash_point adiabatic_process unlocated}}
+{{tag> thermodynamics ideal_gas_law compression flash_point adiabatic located}}
 <WRAP box right>
@@ Line 23: / Line 23: @@
 ===== Setup =====
-  - Place a small piece of flammable material((brown paper towels bought in stores work, cotton balls work best. The greater the surface area-to-mass ratio, the better.)) in the glass tube by unscrewing the bottom platform. You can also drop it into the top and use a ramrod to push it down.
+  - Place a small piece of flammable material((brown paper towels bought in stores work, cotton balls work best. The greater the surface-area-to-mass ratio, the better.)) in the glass tube by unscrewing the bottom platform. You can also drop it into the top and use a ramrod to push it down.
   - Before screwing the platform back, ensure the piston/plunger is at the top of the cylinder (The ideal spot is marked with a line), then screw the platform back while holding the plunger at the line.
   - Push down quickly with a significant force.
@@ Line 49: / Line 49: @@
 </WRAP>
 <WRAP tablewidth 100%>
-| **Location** | ---- |
+| **Location** | C3 |
 | **Maker** | Unknown |
 | **Current State** | Working |